By the late 1950's it was apparent that N2O4 by itself was a better oxidiser. Therefore nitric acid was almost entirely replaced by pure N2O4 in storable liquid fuel rocket engines developed after 1960. The composition of propellant-grade nitric acids is covered by Military Specification MIL-N-7254. The nitric acids are fuming liquids which vary from colorless to brown, depending on the amount of dissolved N2O4. The vapours from these acids have a characteristic pungent odour. They are highly corrosive, toxic, oxidising agents and attack most metals. They react with most organic materials violently enough to cause fire. The acids are soluble in water in all proportions, with an accompanying evolution of heat. They cannot be made to explode. Approximately 90 per cent of the nitric acid is made by the catalytic oxidation of ammonia with air or oxygen to yield nitric oxide (NO). The latter is oxidised to N2O4 which, when treated with water, yields nitric acid (HNO3) and may be concentrated by distillation with sulphuric acid. Red fuming nitric acids may be produced by passing gaseous N2O4 into nitric acid, a slight modification of the above process. Production of nitric acid was estimated at 3 million tonnes in 1959. The price of RFNA was $ 0.20 per kg in drum lots; IRFNA was slightly higher. The varieties of nitric acid propellants include:

• WFNA - White fuming nitric acid is based on anhydrous nitric acid (HNO3), a colourless corrosive liquid which fumes in moist air. They contain a maximum of 2 per cent water and 0.5 per cent nitrogen dioxide, and decompose to yield amounts of water, nitrogen dioxide, and oxygen which are in chemical equilibrium.

• IWFNA - Inhibited white fuming nitric acid. Since container materials are attacked by WFNA and equilibrium products, 0.6 per cent HF is added for passivation by deposition of a protective metallic fluoride coating.

• RFNA - Red fuming nitric acid. Since WFNA or IWFNA exhibit excessive equilibrium decomposition pressures, reaching 75 bar at 700 deg C. To suppress the high pressure through a mass-action effect, some 13 per cent N2O4 and 3 per cent H20 are added, in order to reduce equilibrium pressures to 2 bar at 700 deg C. The colour of the resulting red fuming nitric acid is imparted by N204.

• IRFNA - Inhibited red fuming nitric acid. Addition of 0.6 per cent HF to RFNA produces inhibited RFNA (IRFNA). The IRFNA specification was published in 1954 and thereafter Russian rocket engines using the same fuel appeared.

• AK20 - Russian formulation consisting of 80% nitric acid + 20% N2O4 (AK = Azotna Kislota = Nitric Acid)

• AK20F - Russian formulation consisting of 80% nitric acid + 20% N2O4 + fluorine passivant

• AK20I - Russian formulation consisting of 80% nitric acid + 20% N2O4 + iodine passivant

• AK20K - Russian formulation consisting of 80% nitric acid + 20% N2O4 + unknown additive

• AK27I - Russian formulation consisting of 73% nitric acid + 27% N2O4 + iodine passivant

• AK-27P - Russian formulation consisting of 73% nitric acid + 27% N2O4 + unknown additive

• Slightly higher empty mass for the rocket stage

• Slightly lower performance than storable liquid propellants

• Transportability issues: Solid propellants are cast into the motor in the factory, unlike liquid fuel rockets which can be fueled at the launch pad. This means they have to either be: 1) limited in size to be transportable (as for the Delta and Ariane strap-on motors); 2) cast in segments, with the segments assembled at the launch base (as for Titan and the Space Shuttle); or 3) cast in a factory at the launch site (actually done for large test motors intended for Saturn V upgrades).

• Once ignited, they cannot be easily shut down or throttled. Thereafter they have to be pre-cast or milled out for a specific mission.

• Nearly always catastrophic results in the event of a failure

Advantages of solid rocket motors, many of which make them ideal for military applications:

• High density and low volume

• Nearly indefinite storage life

• Instant ignition without fuelling operations

• High reliability